Before installing interior films, please review the following information concerning the storage and handling of our products to maintain its high quality.
CHECK THE CONDITION AND TYPE OF SURFACE BEFORE APPLYING
Adhesion can be weakened due to moisture. If installing on non-solid surfaces like MDF or drywall make sure to remove moisture (e.g. increase room temperature to 60-75 degrees (F) for 12-24 hours.
Post-installation protect substrate from moisture intrusion which can weaken the adhesive bond
If product has been stored outdoors in cooler weather open the carton and store the product indoors between 60-75 degrees (F) for 12-24 hours. Installation of film that is below 60 degrees (F) may result in adhesive cracking or weakening.
Note that any residual oil, wax, or other surface contaminants can weaken the adhesive bond between the adhesive and the substrate.
We recommends the use of a primer applied to any non-solid surface. Adhesion around edges and corners of any surface will be enhanced by use of a primer. Contact for recommended primers.
After using a primer, allow at least two hours before applying interior film.
To prevent creasing, stretching, or tearing use minimum force when using a squeegee and/or using heat to apply the product to flat or curved surfaces.
Consider using additional pressure when applying thick patterns like artificial leather, papers, or stone.
STORING BODAQ FILMS
Store interior films in the original shipping carton to avoid denting the role or damaging the surface of the film.
Store interior film between 60 degrees and 75 degrees (F) if possible and below 50% relative humidity and out of the direct rays of the sun.
Interior film should not be used for exterior applications.
After installation, extended exposure to ultra violet radiation can cause discoloration.
Although the surface of interior film is very durable, it should be protected from repeated or severe abrasion.
Recommended to sore product at room in temperature of 15~25°C to make the best function.